Skip to main content
Help
Editing Step 2 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Lift the RAM module to an angle of about 30 degrees and slide it out.

When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.

To install a new RAM module, slide it in place at about the same angle until it is snug, and then swing it downward until the two clips snap into place.

Your contributions are licensed under the open source Creative Commons license.