Skip to main content
Help
Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 11 guides that include this step.

Step Type:

Drag to rearrange

Allow the EMI shield to hang down from the display.

Remove the four 8 mm with 2 mm thick head coarse-thread T10 Torx screws securing the display to the rear case.

These screws are recessed, so a thin screwdriver such as this is essential for removal. Bit drivers tend to be too short for this application.

It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac.

Your contributions are licensed under the open source Creative Commons license.