Skip to main content
Help
Editing Step 10 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Find a connector on the motherboard labeled HD TMP or HDD TEMP.

If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive.

If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it.

Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled HD TMP or HDD TEMP.

The connector is keyed to fit in one way only. If it seems like the connector is not fitting the socket, flip the connector and try again.

Route the excess wire so it does not interfere with any other components.

Your contributions are licensed under the open source Creative Commons license.