Skip to main content
Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

Remove the following four press-fit connectors with the flat edge of a plastic spudger or opening tool:

Front-facing camera connector.

Rear-facing camera connector.

Digitizer connector.

The rear-facing camera may be held down to the frame with two sided tape. Try to move the camera with the spudger prior to lifting the motherboard If it does not budge, use the same tool to pry it from the frame to avoid damaging the connector cable in the next step.

Your contributions are licensed under the open source Creative Commons license.