Skip to main content
Help
Editing Step 14 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 8 guides that include this step.

Step Type:

Drag to rearrange

Use the flat end of a spudger to disconnect the front-facing camera connector from the logic board.

Pry up only on the connector—not on the socket itself.

Fold the front-facing camera cable out of the way.

There is a bit of conductive adhesive between the gold-colored cable contacts. Be sure to apply pressure to readhere these contacts during reassembly.

Your contributions are licensed under the open source Creative Commons license.