Help
Editing Step 6 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Lift up the front panel, forming a 90 degree angle with the back panel. Locate the locate ten pin connector shown. This is the wire that connects the front panel to back panel.

Press down on the small tab located on the connector. With the tab firmly pressed down, pull the connector out from its socket.

The faceplate assembly is now fully detached from the rest of the speaker.

Your contributions are licensed under the open source Creative Commons license.