Skip to main content
Help
Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Locate the line on the right side where the front panel and back panel meet. Place a plastic opening tool in the gap, and run it along the gap. Repeat this on the left side.

Use the opening tool to lift the front plate. If a plastic tool is not providing enough leverage, use a metal opening tool.

Gently pull up on the face plate to ensure it has been detached from the enclosure.

When pulling on the face plate be cautious because it is still connected by wires on the back of the plate.

Your contributions are licensed under the open source Creative Commons license.