Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Use the broad edge of the plastic spudger and a lot of force to pop off the speaker from the headset.

Insert the plastic spudger in between the speaker and the headset directly in line with one of the exposed screws of the headset casing, since that is where the four clamps that hold the speaker to the headset are located. These clamps are not visible until after speaker removal.

Make sure to insert the spudger in between the foam buffer-ring and the headset casing instead of in between the speaker and the foam buffer-ring.

Reassembly may be tricky, continue rotating the speaker until the clamps align and you hear the clamps snap in.

Your contributions are licensed under the open source Creative Commons license.