Skip to main content
Help
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

After all the above steps have been completed, proceed by removing the glass face

Carefully insert a plasic spudger in the small gap that exist in between the glass face and the plastic back

Run the plastic spudger all around the scale to increase the gap size

Place a plastic spudger in every corner, since the feet of the scale are also attached to the glass face using adhesive

Carefully insert the metal spudger underneath the adhesive that is located underneath the feet of the scale, and gently keep pushing until the adhesive is out of place

Repeat the above steps four times

After all the adhesives has been removed, gently lift the glass face off

Your contributions are licensed under the open source Creative Commons license.