Skip to main content
Help
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 5 guides that include this step.

Step Type:

Drag to rearrange

If you have the original version of the MacBook Air (A1237), refer to picture 1. Remove the following screws securing the heat sink to the logic board:

One 5.9 mm Phillips screw.

Two 1.9 mm Phillips screws.

One 1.9 mm Phillips screw.

If you have the A1304 version of MacBook Air, refer to picture 2. Remove the following screws securing the heat sink to the logic board:

One 5.0 mm Phillips screw

Five 1.9 mm Philips screws.

One 2.5 mm Phillips screw.

Your contributions are licensed under the open source Creative Commons license.