Skip to main content
Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 10 guides that include this step.

Step Type:

Drag to rearrange

Use a heat gun or hair dryer to soften the adhesive underneath the camera cover.

The following steps were performed without the use of a heat gun. Notice that the camera cover cracks very easily if you do not heat the adhesive that holds it in place.

Gently pry up the bottom edge of the camera cover with a plastic opening tool.

Carefully slide the plastic opening tool across the bottom edge to free it from the adhesive.

Continue to use the heat gun as needed to soften the adhesive as you remove the camera cover.

Your contributions are licensed under the open source Creative Commons license.