Skip to main content
Editing Step 4 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 5 guides that include this step.

Step Type:

Drag to rearrange

Wedge a plastic opening tool between the front and back panel, on the bottom right corner.

Slowly push the tool down to make a small gap between the front panel and the back panel.

Holding the tool steady, run the tool along the bottom part of the device from right to left. This will make the gap between the front panel and the back panel bigger.

When wedging your tool into the device, make sure to apply the pressure to the screen and device at a slow but steady speed to the screen. Too much pressure too fast can crack the screen.

Your contributions are licensed under the open source Creative Commons license.