Skip to main content
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Use two blue plastic opening tools to remove the three wire connectors on the side of the input/output board.

Use a Philips #0 screwdriver to remove the five screws on the board.

One of the screws is hidden below the black tape, so gently pull the tape to the side to gain access to it. Be sure to replace the tape when reinstalling the board.

Lift board from case.

Your contributions are licensed under the open source Creative Commons license.