Skip to main content
Help

Notice: You are editing a prerequisite guide. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Only trained and qualified personnel should be allowed to install, replace, or service this equipment!

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself!

Make sure that the power switch is turned to standby and that the power supply cable is disconnected. Disconnect all cables from the router back panel.

Use the Phillips #1 Screwdriver to remove the two screws on back side of the device.

Your contributions are licensed under the open source Creative Commons license.