Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Editing Step 14 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.

Press the tip of the soldering iron onto the solder bead until it melts.

Slide the exposed end of the lead into the liquid solder until it is in the center of the bead, then remove the soldering iron.

Continue with the other connections the same way, taking special care not to solder two of the pads together.

Your contributions are licensed under the open source Creative Commons license.