Skip to main content
Help
Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

The next few steps require a soldering iron.

The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.

Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light continuous tension while the soldering iron heats up the connection. As soon as the solder melts and the lead slides out, immediately lift the solder tip off the connection to avoid damage.

Your contributions are licensed under the open source Creative Commons license.