Skip to main content
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Use a Phillips #1 screwdriver to remove the following screws from the device:

Four 7.0mm Phillips screws

Three 6.0mm Phillips screws

Two 10.0mm Phillips screws

These two screws are behind the barcode decal on the bottom of the device. Expose the screws by puncturing, cutting, or peeling the barcode decal.

Your contributions are licensed under the open source Creative Commons license.