Skip to main content
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Lift the camera body out of the plastic frame by using two small plastic opening tools as follows:

Place one opening tool directly under the base of the camera ribbon cable and camera body, applying upward pressure.

At the same time, use the other tool to release one of the clips on the left or the right of the camera body.

The left side of the camera body is shown here as the top, with the right side shown as the bottom.

Be careful not to bend the retaining clips too far as this can damage them.

Your contributions are licensed under the open source Creative Commons license.