Skip to main content

Fix Your Stuff

Right to Repair

Store

Help
Editing Step 4 —

Step Type:

Drag to rearrange

After you put the USB / SD circuit board back into the bottom half of case, seal it with something like plastidip or silicone sealant.

Resolder the speaker wires

Clean the connectors with 100% alcohol or lighter fluid (naphta) to ensure good contact

Then reassemble the whole unit

Be gentle when tightening the torx screws, as the thread in plastic is quite easy to strip with too much torque (If you're curious how I know it, look closely at the pictures :)

Your contributions are licensed under the open source Creative Commons license.