Help

Editing Step 2 — Add a title

Notice: You are editing a prerequisite guide. Any changes you make will affect all 20 guides that include this step.

Step Type:

Drag to rearrange

Use a plastic opening tool to pull the pressure contact from underneath the battery connector.

When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.

Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.

Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!

Your contributions are licensed under the open source Creative Commons license.