Skip to main content

Fix Your Stuff

Right to Repair


Editing Step 14 —

Step Type:

Drag to rearrange

Insert the leads of the 240 Ω resistor through the holes indicated in step 7. This resistor will have a red, yellow, brown, and gold band on it. The direction of the resistor does not matter.

Be sure to route the leads so that they do not cover any needed holes from steps 7 and 8. Also, do not allow the leads to contact the leads of other components.

Solder the resistor to the PCB and clip the excess leads off.

Your contributions are licensed under the open source Creative Commons license.