Skip to main content
Help
Editing Step 4 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

The inverter board is the smaller board in the corner.

Remove the three 7.69 mm Phillips #2 screws from the inverter board.

Remove the two 7.69 mm Phillips #2 grounding screws from the wire with the black connector.

Gently pull the inverter board away from the case. Note that the board is still connected to several components by wires.

Your contributions are licensed under the open source Creative Commons license.