Help
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 16 guides that include this step.

Step Type:

Drag to rearrange

Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.

Insert the flat end of a spudger into the gap.

The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

While pulling up on the suction cup, twist the spudger to widen the opening between the screen and rear case.

Your contributions are licensed under the open source Creative Commons license.