Help
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 16 guides that include this step.

Step Type:

Drag to rearrange

Pull up on the suction cup to create a small gap between the display assembly and the rear case.

Insert the flat end of a spudger into the gap.

The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

Your contributions are licensed under the open source Creative Commons license.