Skip to main content

Fix Your Stuff

Right to Repair


Editing Step 4 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Support the display with one hand as you remove the remaining T8 screws.

Remove the two T8 Torx screws from each side of the display (highlighted in red boxes).

When replacing the display, make sure that the right screw pins down the ground loop from the display data cable.

Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles) and deroute them from under the other cabling.

Your contributions are licensed under the open source Creative Commons license.