Skip to main content
Help
Editing Step 7 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Remove the three 3 mm T10 screws securing the hard drive to the Xbox.

There is one screw on the rear left side of the hard drive that is only visible when the IDE ribbon cable is lifted up. The other two are at the front right and left sides of the hard drive.

The screw on the lower left corner of the disk drive is not in the hole that it appears to be in, but rather just closer to the corner.

Your contributions are licensed under the open source Creative Commons license.