Skip to main content

Fix Your Stuff

Right to Repair

Store

Help
Editing Step 31 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Remove the battery isolation pick.

Insert a plastic card underneath the logic board at the battery connector.

Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.

As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in Step 60. Position the card exactly as shown.

Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Your contributions are licensed under the open source Creative Commons license.