Skip to main content
Editing Step 28 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

Your contributions are licensed under the open source Creative Commons license.