Skip to main content
Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

Step two is disconnecting and removing the head lamp.

Use a screw driver to remove the 5mm screw. Remove head lamp of drone.

Disconnect the electronics from the frame of the drone by pulling each arm out of the hole in the frame holding it in place.

Do not try to separate the frame from the electronics yet! Check to see if there is tape holding the head lamp wires in place underneath the electronics.

Your contributions are licensed under the open source Creative Commons license.