Get quick access to guides, parts, and answers for your devices
Looks like your cart is empty
Position a wire to the corresponding connection point on the jack.
Carefully apply a small amount of solder to hold the wire in place.
Repeat this for each wire.
Make sure to reference the mapping of wires to connection points that you created in Step 4.
When soldering the wires, be patient and meticulous about getting the right position to make a good connection.
If the internal wires do not have their own insulation, use a small bit of shrink tubing on each wire. This will prevent them from shorting across another wire.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.