Skip to main content

Nintendo 3DS SD Board Replacement

Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 15 guides that include this step.

Step Type:

Drag to rearrange

Insert the flat end of a spudger between the SD board and the motherboard.

Pry up slowly to loosen the SD board from the RF shield underneath it. If you pry too quickly, you may tear the shield or break its solder points.

Run the spudger along the sides of the SD board to free it from the adhesive holding it in place.

Once completely freed, lift the SD board straight off the motherboard.

Your contributions are licensed under the open source Creative Commons license.