Skip to main content

Fix Your Stuff

Right to Repair


Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

Remove the following two screws:

One 3.3 mm Phillips screw

One 2.1 mm Phillips screw

Lift the metal retainer clip straight up from its recess in the rear panel.

If the camera comes up with the retaining clip, don't worry. Just separate the camera from the clip before reinstalling, so you can be sure to get the connector in the right place.

Be sure the small thermal pad is attached to the metal retaining clip as seen in the third picture when replacing the rear camera.

Your contributions are licensed under the open source Creative Commons license.