Skip to main content
Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Use a small iPod opening tool to flip up the black plastic tab holding the orange click wheel ribbon in place. The black tab will rotate up 90 degrees, releasing the ribbon cable.

Use a small iPod opening tool to loosen the click wheel cable from the logic board. Be careful not to bend the cable too much, or the electronics on the cable could be damaged.

Disconnect the click wheel cable from of its connector, and lift the entire click wheel assembly away from the logic board.

The click wheel should now be separate from the rest of the iPod.

Your contributions are licensed under the open source Creative Commons license.