Skip to main content
Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 9 guides that include this step.

Step Type:

Drag to rearrange

Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable.

Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable.

Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task.

If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive.

Your contributions are licensed under the open source Creative Commons license.