Starting from the bottom of the device, using a metal spudger, separate the top (white) plastic piece from the bottom (gray) plastic piece.
Work your way across the bottom of the device, then to each side, and finally to the top.
There are brackets every few inches along the edge of the device. These may be difficult to pull apart.
The top and bottom pieces should separate, and the internals of the device will now be accessible.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.