Skip to main content
Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

The next few steps bring your hands close to the exposed face of the power supply. To avoid a high voltage shock from the many large capacitors attached to the board, do not touch the face of the power supply.

Remove the following four screws securing the power supply to the outer case:

One 9.3 mm T10 coarse-threaded screw

One 25 mm T10 coarse-threaded screw

Two 22 mm T10 fine-threaded screws

Your contributions are licensed under the open source Creative Commons license.