Skip to main content
Editing Step 11 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 14 guides that include this step.

Step Type:

Drag to rearrange

Remove the following 8 screws:

Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

Note for re-assembly:

The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

Your contributions are licensed under the open source Creative Commons license.