Skip to main content
Help
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.

Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.

The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.

After loosening the case, remove it.

There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

Your contributions are licensed under the open source Creative Commons license.