Skip to main content
Help
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

Underneath the control panel will be a flat grey ribbon cable. This cable is attached at the base of the green control board with the other end of the cable located on the back side of the printer's base.

Carefully disconnect both ends of the flat grey ribbon cable to release the control panel in its entirety.

Only pull from the connector portion of the cable, as pulling on the wires may damage them.

Your contributions are licensed under the open source Creative Commons license.