Skip to main content
Help
Editing Step 26 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go.

Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.

If any portion of the logic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.

Your contributions are licensed under the open source Creative Commons license.