Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Remove the following 3 screws:

Two 1.5 mm Phillips #00 screws, one on either side of the dock connector.

One 2.4 mm Phillips #00 screw near the ribbon cable labeled "4."

Lift the dock connector assembly up and out of the iPhone.

When inserting the new assembly, ensure the screw holes of the assembly rest ABOVE the bezel's holes.

Your contributions are licensed under the open source Creative Commons license.