Skip to main content

Fix Your Stuff

Right to Repair

Store

Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 6 guides that include this step.

Step Type:

Drag to rearrange

Remove any kapton tape over the screws, if necessary.

Remove the following 3 screws:

Two 3 mm Phillips screws near the dock connector.

One 4 mm Phillips screw along the edge of the logic board.

During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

Your contributions are licensed under the open source Creative Commons license.