Help
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Gently pull the red and black wires, lifting the white connector upwards, out of its position. (You may need to jiggle the wires from side to side somewhat to loosen the connector.)

Now that all cables and screws are disconnected, you can now remove the flash assembly.

To reinsert, line up connector with the copper leads on the camera, and gently press the white piece into place.

The black cable should be closer to the top of the camera.

Your contributions are licensed under the open source Creative Commons license.