Skip to main content
Help
Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

Remove two screws (4.1mm) on the top of the camera using a #000 Phillips head screwdriver.

Using a #000 Phillips head screwdriver remove two screws (7.9mm) near the control panel and set aside the metal connector.

Although the third photo shows the side panel casing being removed, it is normally secured by a screw under the front framework. You'll need to follow the next two steps to remove the framework and access the screw before you can remove the side casing as shown here.

Your contributions are licensed under the open source Creative Commons license.