Skip to main content
Help
Editing Step 6 —

Step Type:

Drag to rearrange

Carefully lift and turnover the LCD Screen so that you are able to see the motherboard.

Treat the motherboard with care since it is very sensitive to static discharge. Remain grounded to avoid the release of static discharge by wearing a static bracelet.

Carefully disconnect the LCD Screen ribbon cable away from its ZIF connector with your thumb and index finger. You must make sure to have your thumb and index finger cover as much of the ribbon's width and as close to the ZIF connector as possible without touching the motherboard while pulling the ribbon out.

Be careful to not rip the ribbon wire or the red and black power wires when pulling the LCD screen out.

You do not have unsolder the the LCD screen if you are only replacing the lens.

Your contributions are licensed under the open source Creative Commons license.