Skip to main content
Help
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Separate the two parts of the body of the camera slightly.

Release the two cables by lifting up their respective clips with a spudger.

Make sure not to pull too hard because there are connector ribbons.

Detach the connector ribbons before fully separating the camera into two pieces.

These pictures were taken after the connector ribbons were released and the camera was separated into two parts. You will need to release the connector ribbons while the camera is still in one piece before you can separate it like the pictures.

Your contributions are licensed under the open source Creative Commons license.