Skip to main content
Editing Step 45 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Carefully insert the flat end of a spudger between the rear-facing camera and the top of the logic board.

Pry the logic board up enough to grab it with your fingers.

Be extremely careful not to damage the rear-facing camera cable, or any logic board components.

If the logic board does not lift easily, there may still be adhesive holding it to the rear case. Try sliding the pick farther before prying again.

Your contributions are licensed under the open source Creative Commons license.