Skip to main content
Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Using the flat end of a spudger, pry the left speaker out of its socket on the front bezel.

De-route the speaker cable along the top edge of the screen.

Work carefully and slowly, holding onto the wire and not the speaker itself. The solder joints may break if pulled on too hard.

In the same manner described above, remove the right speaker from its socket on the front bezel.

Place both speakers on the back of the upper LCD.

Your contributions are licensed under the open source Creative Commons license.