Skip to main content
Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 6 guides that include this step.

Step Type:

Drag to rearrange

If necessary, peel the EMI gasket off the camera cable connector.

Disconnect the camera cable by pulling the male end straight away from its socket toward the optical drive opening.

Do not try to lift this connector straight up off the board. Pull the connector parallel to the face of the logic board.

Deroute the camera data cable from the channel in the optical drive.

Your contributions are licensed under the open source Creative Commons license.