Skip to main content
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Turn the logic board assembly over to access the heat sink's x-clamp.

To avoid ESD damage, be sure to lay your logic board on a soft, static free surface during service.

Starting at the front left corner of the x-clamp, insert a 1.5 mm flathead screwdriver between the heat sink's peg and the x-clamp's hook.

Gently rotate the screwdriver counterclockwise, releasing the x-clamp's hook from the peg.

The logic board is very sensitive to impact and scratching. Be sure to not let the screwdriver slip and damage the logic board.

Your contributions are licensed under the open source Creative Commons license.